Rubber Moulded Components

All the non standard seals are the result of the same vulcanization process described under the section concerning o-rings. However, these parts are of the most varied shapes and therefore are ‘special products’; Reference then below, will only be made to the differences in the production process that derive from the difference of geometric shape.

While for o-rings, the simple indication of the two sizes of the internal diameter and the section is sufficient to identify the exact item required, for the special parts, the customer has to provide a detailed technical drawing of the part.

Based on this drawing, our Company's task is to identify the geometric shape and the exact configuration of the part required, to enable supply of the part as shown.

These products are also moulded by injection presses in order to permit a perfect balance between constant quality levels and cost control.